This kit allows users of most Ruida-Controlled lasers to add or upgrade their Air Assist

This is a hand built solution for each machine which may impact your specific delivery time. Please contact us prior to ordering to verify delivery estimates and the build needed for your machine.

Single Solenoid Kit:
Allows lightburn to control standard vs high airflow. Air will continuously flow while the compressor is hooked up even if the laser is off.

Dual Solenoid Kit:
This kit will shut air off unless a job is running, it turns on low flow for engraving and high flow for when air is enabled for a layer in lightburn.

Includes Manual for installation. Support is available for installation.
Manual will be linked via QR Code inside shipping box.

Tools Required:
Scissors for Cutting Tube
Precision Flat Screwdriver (For Terminal Connectors)
Drill - Switch or Connector may require holes to be drilled.
Air Compressor

Recommended:
Volt Meter

Please contact us at [email protected] if you have any questions in regard to the function or installation of this product.